1 Dana 300 Rotation Plate Manufactured by JB CONVERSIONS, INC. Phone: 337-625-2379 Installation Instructions Part No. 15-1102 Instruction R
2 3) Remove the retaining ring from the input shaft. 4) Remove the helical gear from the input shaft. Usually, this gear is fairly tight t
3 5) Remove the retaining ring from the original bearing retainer. 6) Remove the original bearing from the retainer using a press. Usually this
4 8) Install the original bearing (removed in step 6) and retaining ring into the new clocking plate. 9) Place the shims on the new input
5 10) The gear should be pushed or pressed into place against the bearing. 11) Install the input drive gear onto the spline of the input shaft f
6 12) Using a gap gauge, check for 0.00"-0.003" clearance below the retaining ring. If clearance is insufficient, adjust shims as
7 14) Clean the gasket face of the Dana 300 and apply a very thin bead of black RTV to the case. 15) Install the clocking plate and
Comments to this Manuals